Broken plastic sunrise - FPV - Gimbal - Super-H600

A nice sunrise flight using my gimbal mod for my Super-H600 quad. it turns out that my gimbal works better without the orange RC bobbins(vibration dampeners) because on my first test flight without the bobbins installed it had no shake at all. The crash was caused by a cheap green hobbyking 10x45 plastic propeller failing for no reason in a gradual dive. lucky i wasnt further out over the water. The Super-H600 quad only sustained a few slight rips in the g10 fibre board but nothing that will affect the rigidity of the frame the only other damage was the gimbal getting ripped off its mount due to the shear force of the impact but i fixed that with some liquid nails(strong glue). i have decided that i will never intrust my quad to those cheap hobbyking props again instead i'll bite the shipping bullet and get some Graupner 10x5 carbon fibre propellers.
SETUP:
1 Super-H 600 QuadCopter (KIT)
4 NTM Prop Drive 28-30S 800KV / 300W Brushless Motor (short shaft version)
4 28 series accessory packs
4 Turnigy Multistar 20 Amp Multi-rotor Brushless ESC 2-4S(great but i'm going to flash them to simon k just because i have never experienced simon k yet),
1 Battery Strap 300X20mm (Black) (4pcs/bag)
Hobbyking Quadcopter Power Distribution Board
10x4.5 SF Props 2pc CW 2pc CCW (Green)
Hobbyking KK 2.1 Multi-rotor LCD Flight Control Board With 6050 MPU And Atmel 644PA
4 3.5mm Male Female Bullet Brushless Motor Extension Lead 100mm or 200mm
Gopro hero 3 black
Fatsharks altitude SD FPV System
Easy mod for a RTF quad's gimbal($55)
Gens ace 4s 3300mah battery(flight battery)
Turnigy 1500mah 3s(FPV and gimbal battery)
Spektrum DX7S (using satellite receiver and AR8000)
Orange RC bobbins from a QAV series quad
SpiroNET 5.8GHz circular polarized antenna from ImmersionRC and FatShark.