Sub250g FPV Drone Build - 02 - Frame, ESC & Motors

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST:
SUPPORT ME ON PATREON at:
THIS IS MY FULL TIME JOB. Here are other ways that you can support me: /
---
I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.
Buy the Analog Sub250g build kit at:
* GetFPV -
* RaceDayQuads -
Buy the HD-Ready Sub250g build kit at:
* GetFPV -
* RaceDayQuads -
M2 screw assortment:
M3 screw assortment:
Practice solder board:
* GetFPV -
* RaceDayQuads -
ViFly Short-Saver
* GetFPV -
* RaceDayQuads -
---
All videos in this series are in this playlist:
---
00:00:00 - This is part of a series
00:01:06 - Mount the motors to the frame plate
00:04:12 - Assemble the front and rear bottom plates
00:08:09 - Install the FC
00:15:14 - Now the pain begins: soldering
The soldering tutorial that you should watch:
00:17:01 - Install the capacitor
00:20:51 - Solder the XT30 and capacitor to the FC
00:24:55 - Solder the motor wires to the ESC
00:30:05 - Smoke Check
00:33:08 - Conclusion